Extinguishers in shops and on the line: currency, condition, mounting, access. (flightline extinguishers · shop extinguishers · monthly checks)
Firefighting protective clothing and For Triethylaluminum (TEA), Platinum (PT) or Thorium (TH): IAW applicable National Fire Protection Association equipment may be used) - Do not use water. Standards 1991, 1992 and 1994. - Do not look at burning material. FIREFIGHTING DIRECTION SYMBOLS WEAR BREATHING APPARATUS APPLY NO WATER -Approach from upwind and extinguish fire. - Munitions burn with extremely high temperature and - Wear breathing apparatus: consists of a self contained are difficult toextinguish. breathing apparatus. (Firefighting protective clothing - Water is NOT a suitable extinguishing agent as it may and equipment may be used) intensify the fire. - Do not look directly at the burning material or eye damage may result. AFVA 91-216, 4 APRIL 2012, Certified Current on, 4 June 2020
contained breathing apparatus. (Firefighting protective clothing and equipment may be used.) AF Hazard Symbol: E APPLY NO WATER - Munitions burn with extremely high temperature and are difficult to extinguish. - Water is NOT a suitable extinguishing agent as it may intensify the fire. - Do not look directly at the burning material or eye damage may result. AF Hazard Symbol: A SET 1 of chemical hazard symbol 1 - Withdraw upwind. - If explosion does not occur, approach from upwind and extinguish fire. - Decontamination may be required. - Set 1 consists of self-contained breathing apparatus and chemical-protective clothing with flash protection IAW applicable NFPA Standards 1991, 1992, and 1994. DESR 6055.09, Edition 1, Change 1, February 23, 2024 VOLUME 1 – ENCLOSURE 10: HAZARD IDENTIFICATIO
5. All fire extinguishers will meet the requirements of NFPA 10, Standard for Portable Fire Extinguisher. (T-1) Note: TO 13F4-4-121, Fire Extinguisher, Wheeled Liquified Gas, 150 LB Capacity, and NFPA 10 are to be used for maintenance and inspection of wheeled flightline fire extinguishers. 6.2.6.6. Employee Responsibilities. All employees are responsible for fire extinguishers in their work areas. Employees will ensure fire extinguishers are readily accessible with unobstructed access and are used only for the intended purpose. (T-0) F&ES Flights will be notified of any fire extinguisher discharge, accidental or intentional. (T-3) 6.2.6.7. Supervisor Responsibilities. Supervisors are responsible for fire extinguishers in areas under their control. Supervisors will: 6.2.6.7.1. Perform visu
direct installation of extinguishers in military family housing, procedures will be developed to ensure occupants are trained in their use and extinguishers are maintained. (T-3) 6.2.6.3. Fire Extinguisher Location. The F&ES Flight will approve the location of all fire extinguishers. (T-3) 6.2.6.4. Fire Extinguisher Purchase and Maintenance. Facility managers and using organizations will budget for the purchase and maintenance of fire extinguishers. (T-3) Note: 150-pound flightline fire extinguisher programs are maintained under the Aircraft Maintenance Squadrons or Generation Squadrons as required per HAF Mission Directive (HAFMD) 1-38, Deputy Chief of Staff, Logistics, Engineering and Force Protection. 6.2.6.5. All fire extinguishers will meet the requirements of NFPA 10, Standard for Po
.95 for requirements, and NFPA 10 for inspections. (T-0) V1.E10.6.16.3. (Added)(DAF) Ensure at least one fire extinguisher is available for each item of powered MHE used to handle AE. (T-1) V1.E10.6.16.3.1. (Added)(DAF) Individual fire extinguishers are not required for each piece of handling equipment during explosive operations if the requirements of paragraph V1.E10.6.16. are met. V1.E10.6.16.3.2. (Added)(DAF) If handling equipment is used to transport AE to a location where a second fire extinguisher is not immediately available, two portable fire extinguishers with a 2A:10BC rating or more are required for the handling equipment. (T-0) V1.E10.6.16.4. (Added)(DAF) Provide flightline fire extinguishers for aircraft according to munitions loading manuals, DAFMAN 91-203, and TO 00-25-172.
structure with a roof or ceiling and at least two walls which may present fire hazards to employees, such as accumulations of smoke, toxic gases and heat, similar to those found in buildings. (16) Extinguisher classification means the letter classification given an extinguisher to designate the class or classes of fire on which an extinguisher will be effective. (17) Extinguisher rating means the numerical rating given to an extinguisher which indicates the extinguishing potential of the unit based on standardized tests developed by Underwriters' Laboratories, Inc. (18) Fire brigade (private fire department, industrial fire department) means an organized group of employees who are knowledgeable, trained, and skilled in at least basic fire fighting operations. (19) Fixed extinguishing syste
l other employees in the fire area to immediately evacuate the affected work area upon the sounding of the fire alarm, the employer is exempt from the distribution requirements in paragraph (d) of this section. (c) General requirements. (1) The employer shall provide portable fire extinguishers and shall mount, locate and identify them so that they are readily accessible to employees without subjecting the employees to possible injury. (2) Only approved portable fire extinguishers shall be used to meet the requirements of this section. (3) The employer shall not provide or make available in the workplace portable fire extinguishers using carbon tetrachloride or chlorobromomethane extinguishing agents. (4) The employer shall assure that portable fire extinguishers are maintained in a fully
plied to all points in the area. (iv) One or more fire extinguishers, rated not less than 2A, shall be provided on each floor. In multistory buildings, at least one fire extinguisher shall be located adjacent to stairway. (v) Extinguishers and water drums, subject to freezing, shall be protected from freezing. (vi) A fire extinguisher, rated not less than 10B, shall be provided within 50 feet of wherever more than 5 gallons of flammable or combustible liquids or 5 pounds of flammable gas are being used on the jobsite. This requirement does not apply to the integral fuel tanks of motor vehicles. (vii) Carbon tetrachloride and other toxic vaporizing liquid fire extinguishers are prohibited. (viii) Portable fire extinguishers shall be inspected periodically and maintained in accordance with M
ng that cannot be closed, precautions shall be taken so that no readily combustible materials on the floor below will be exposed to sparks which might drop through the floor. The same precautions shall be observed with regard to cracks or holes in walls, open doorways and open or broken windows. (ii) Fire extinquishers. Suitable fire extinguishing equipment shall be maintained in a state of readiness for instant use. Such equipment may consist of pails of water, buckets of sand, hose or portable extinguishers depending upon the nature and quantity of the combustible material exposed. (iii) Fire watch. (A) Fire watchers shall be required whenever welding or cutting is performed in locations where other than a minor fire might develop, or any of the following conditions exist: (1) Appreciabl
Ladders.. (a) Application. The employer must ensure that each ladder used meets the requirements of this section. This section covers all ladders, except when the ladder is: (1) Used in emergency operations such as firefighting, rescue, and tactical law enforcement operations, or training for these operations; or (2) Designed into or is an integral part of machines or equipment. (b) General requirements for all ladders. The employer must ensure: (1) Ladder rungs, steps, and cleats are parallel, level, and uniformly spaced when the ladder is in position for use; (2) Ladder rungs, steps, and cleats are spaced not less than 10 inches (25 cm) and not more than 14 inches (36 cm) apart, as measured between the centerlines of the rungs, cleats, and steps, except that: (i) Ladder rungs and steps in elevator
Ask a variation Export proof pack ⎙
Derived from the indexed corpus (rebuilt on refresh · this page built 2026-07-14). The checklist of record is your command's RIL / MICT listing — this page is training context.
Other inspections: AGE Ready Line / In-Use Inspection · CTK / Tool Accountability Inspection · TMDE / Calibration Check · FOD Prevention Inspection · Flightline Vehicle Inspection · Grounding Points & Static Grounds · Aircraft Towing Observation · Aircraft Jacking Observation · Refuel / Defuel Observation · Corrosion Control Inspection · Forms & Documentation Review · Technical Data Compliance Evaluation · HAZMAT / Flammables Storage Inspection · Impoundment Procedures Review
New and updated AFIs, supplements, and OSHA cross-references as we index them — straight to your inbox.