Ask a compliance question

are maintained by the Inventory Control Point's packaging activities within the Military Service or Defense Agency, or within the military service's system commands. Packaging data retrieval is available from the managing Military Department's or Defense Agency's automated packaging files, CD-ROM products, or by contacting the responsible packaging activity. 6. NOTES (This section contains information of a general or explanatory nature which may be helpful, but is not mandatory.) 6.1 Intended use. The combination of all properties of MIL-PRF-85285: component, liquid, cured topcoat, resistance, mixing, application, cleanability, strippability; along with the composition and solvent content, provide the necessary requirements for a topcoat used in the extremes of the naval aviation environme

is the current version before use. MIL-PRF-85285F w/AMENDMENT 1 22 6.5 Qualification. With respect to products requiring qualification, awards will be made only for products which are, at the time of award of contract, qualified for inclusion on the Qualified Products List, QPL-85285, whether or not such products have actually been so listed by that date. The attention of the contractors is called to these requirements, and manufacturers are urged to arrange to have the products that they propose to offer to the Federal Government tested for qualification in order that they may be eligible to be awarded contracts or orders for the products covered by this specification. Information pertaining to qualification of products may be obtained from the Commanding Officer, Naval Air Warfare Cente

requirements for a topcoat used in the extremes of the naval aviation environment. There are no commercial equivalents that meet the combination of all properties of MIL-PRF-85285. Type I of this topcoat is intended for use on aircraft weapons systems and other applications. Type II is intended for use on support equipment. Type III is intended for use on aircraft and support equipment. Type IV is intended for use on aircraft weapons systems where extended weatherability is necessary. Type IV is a direct replacement for type I on aircraft weapons systems. No additives other than the appropriate thinner for class H and NH, nor deionized or distilled water for class W and NW to obtain the proper spray viscosity need to be added. 6.2 Acquisition requirements. Acquisition documents should spe

bited, Fire Resistant, Synthetic Hydrocarbon Base, NATO Code No. H-544 MIL-DTL-53072 - Chemical Agent Resistant Coating (CARC) System Application Procedures and Quality Control Inspection MIL-PRF-81733 - Sealing and Coating Compound, Corrosion Inhibitive MIL-PRF-81322 - Grease, Aircraft, General Purpose, Wide Temperature Range, NATO Code G-395 MIL-PRF-83282 - Hydraulic Fluid, Fire Resistant, Synthetic Hydrocarbon Base, Metric, NATO Code Number H-537 MIL-PRF-85285 - Topcoat, Aircraft and Support Equipment MIL-PRF-85582 - Primer Coatings: Epoxy, Waterborne MIL-PRF-87252 - Coolant Fluid, Hydrolytically Stable, Dielectric MIL-PRF-87257 - Hydraulic Fluid, Fire Resistant, Low Temperature, Synthetic Hydrocarbon Base, Aircraft and Missile DEPARTMENT OF DEFENSE STANDARDS MIL-STD-186 - Protective Fi